Jump to content

Direct fracture with splines


Recommended Posts

This is more difficult then i thought it would be. So I have a plate that i want to break into jig saw pieces. I have drawn these as avector and imported them. The solid plate has a voronoi parent and the generator is set to the spline object. I was hoping to get clean jigsaw pieces with the voronoi. But i can't get it to work. Not with all the splines pieces connected nor as a single source. Any suggestions how i could achive this?

 

Thanks

Philip

 

jig saw voronoi

Link to comment
10 hours ago, deck said:

you could make all the puzzle pieces as regular extrusions with caps set to make single object, then put all those into a regular fracture object.

Deck

Ah yes but then i would lose the shape of the plate in Y. But wait i could project the spline onto the plate object first and then extrude if the spline is subdivided enough?

 

Philip

Link to comment
10 hours ago, bezo said:

Or you could cut with knife with your puzzle spline directly into surface...

Good one bezo, didn't know i could do that. Place spline over object in perspective view, spline active, points mode, ctrl click knife on spline and done  according to this tut

 

https://youtu.be/8jXMMF10Voc?t=189

 

The tutorial was helpfull too though i will have to brush up my Czech

Link to comment
×
×
  • Create New...

Copyright Core 4D © 2023 Powered by Invision Community